ArtDio IPS-1000 Manual do Utilizador descarregar pdf (Página 20)

1000 Series VoIP Gateway

Every time you set parameters, press the “#” key to complete it, a successful setting will be confirmed by three equal beeps in

succession. If your settings were not succeeded you will be prompted with one long beep.

The Command length is two-digits long. For example, configure “area code” is “01”, “phone number” is “02”, and

“restart” is “98”, etc... For details please refer to section 9.5. Appendix E: Phone Set Command Codes and Parameters.

5.3.2.1 Static IP

If you are using a static IP, you need to prepare the information as specified in section 4.2. IP Address, as an example as

below:

Area Code 626 (Los Angeles)

Phone Number 4453447

IP Address 210.67.96.121

Subnet Mask 255.255.255.248

Default Gateway 210.67.96.120

Web Management Password 123

Use the information above as an example. The procedure is as follows:

When the “CPU/ACT” LED is on, pick up the handset and dial as follows:

1. ##0000 ; to start the configuring mode

2. 01626

# ; “626” represents the Los Angeles area code

3. 024453447

# ; phone number

4. 030

# ; “0” is used to enable “manual” IP mode

5. 04210*67*96*121

# ; IP Address

Pick u

the handset

Dial “##0000” to enter

the configuring mode

Command (two digits) +

Parameter (variable length) +

“#” ke

to end

Replace the handset

Set next parameter

1 2 ... 15 16 17 18 19 20 21 22 23 24 25 ... 53 54

Sem comentários

ArtDio IPS-1000 Manual do Utilizador Página 20